Table of Contents
Advertisement
Appendix B: Updating Firmware
The CM-MD64 operating system undergoes a programme of continuous development, as a result the
unit may be updated by loading new versions of the firmware as they become available. This can be
done by connecting an Ethernet cable to the CM-MD64's front panel [11] linked to a Windows PC with
the latest firmware file.
The latest firmware version can be downloaded from Support / Software Download page on the Cadac
website.
Programming the FPGA
To programme the FPGA on the CM-MD64 you will require:
•
A PC / laptop with a web browser (this procedure will not work with a Mac)
•
Ethernet cable (Cat5 or Cat6)
To update the FPGA follow the instructions below:
•
Set the network card on the PC to IP address 169.254.1.2 and the subnet mask to
255.255.0.0.
•
Power cycle the
Power off - wait 5 seconds - power on
•
Connect the PC to the
the unit's front panel.
•
Start the web browser on the PC and type
and press Enter
To find the CM-MD64's current FPGA version type MCOMMS_MADI
bar and press Enter
•
When the page loads you should see MPFS Image Upload plus a Choose File and an Upload
button
•
Select Choose File and a file
•
Browse to and open the MComms_MADI_FPGA_******_A**.bin file
•
Select Upload on the web page
Wait for up to 60 - 90 seconds and Upload successful will appear on the page
•
Programming the FPGA is complete
unit
CM-MD64
unit via the Ethernet cable using the Ethernet port located on
browser window should appear
CM-MD64_24-05-2023_Iss-1.docx
Page. 26 / 31
MCOMMS_MADI/mpfsupload into the address bar
into the address
Advertisement
Table of Contents
