Table of Contents
Advertisement
General Precautions
•
Do not place heavy objects on the Network Bridge, expose it to sharp objects or handle the unit
in any way that may cause damage, e.g., rough handling and /or excessive vibration.
•
Do not subject the equipment to dirt, dust, heat or vibration during operation or storage. Never
expose the Network Bridge to rain or moisture in any form. Should the unit become wet, turn it
off and disconnect it from the mains without further delay. The Network Bridge should be given
sufficient time to dry out before recommencing operation.
•
When cleaning the Network Bridge, never use chemicals, abrasive substances or solvents.
•
The Network Bridge should be cleaned using a soft brush and a dry lint-free cloth. For
persistent marks, use a soft cloth and isopropyl alcohol. Switches and potentiometers do NOT
require cleaning or lubrication.
•
Keep these instructions for future reference. Follow all warnings in this manual and those
printed on the console.
•
The Network Bridge must be connected following the guidance in this manual. Never connect
power amplifier outputs directly to the unit. Connectors and plugs must never be used for any
other purpose than that for which they are intended.
•
The Network Bridge's mains input must always be connected to correctly rated mains power as
referred to in this manual. The mains input must, at all times, be connected to the local mains
power supply using the supplied power cord. In cases where the supplied plug does not fit, a
qualified electrician must be consulted.
•
The power cord must be routed in such a way that the risks of accidentally stepping on it,
stretching it or it being pinched are minimized.
•
WARNING! THIS EQUIPMENT MUST BE EARTHED!
•
Ventilation slots must never be covered or obstructed in any way, otherwise airflow required for
safe operation may be restricted. Where the Network Bridge is to be operated in a flight-case,
then this must be located in such a way that it allows for proper ventilation.
•
Refer servicing to qualified technical personnel only.
CM-MD64_24-05-2023_Iss-1.docx
Page. 5 / 31
Advertisement
Table of Contents
