Restore Factory Settings; Maintenance And Cleaning; General Information About Radio Operation - HomeMatic HmIP-FCI1 Installation And Operating Manual

Contact interface flush-mount – 1 channel
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13

Restore factory settings

9 Restore factory settings
The factory settings of the device
can be restored. If you do this,
you will lose all your settings.
To restore the factory settings of the
contact interface, please proceed as
follows:
• Open the battery compartment (B)
by pulling out the battery holder
(C)
(see
Figure).
• Reinsert the battery holder while
holding down the system button
(A) for 4 seconds until the LED
(A) starts quickly flashing orange
(see
figure).
• Release the system button again.
• Press and hold down the system
button again for 4 seconds until
the status LED lights up green.
• Release the system button to finish
the procedure.
The device will perform a restart.

10 Maintenance and cleaning

The device does not require you
to carry out any maintenance
other than replacing the battery
when necessary. Enlist the help of
an expert to carry out any repairs.
Clean the device using a soft, lint-free
cloth that is clean and dry. Do not use
any detergents containing solvents, as
they could corrode the plastic housing
and label.
11 General information about
radio operation
Radio transmission is performed on
a non-exclusive transmission path,
which means that there is a possibility
of interference occurring. Interference
can also be caused by switching oper-
ations, electrical motors or defective
electrical devices.
The range of transmission within
buildings can differ greatly from
that available in the open air. Be-
sides the transmitting power and
the reception characteristics of
the receiver, environmental fac-
tors such as humidity in the vicini-
ty have an important role to play,
as do on-site structural/screening
conditions.
Hereby, eQ-3 AG, Maiburger Str. 29,
26789 Leer/Germany declares that the
radio equipment type Homematic IP
HmIP-FCI1 is in compliance with
Directive 2014/53/EU. The full text
of the EU declaration of conformity
is available at the following internet
address: www.homematic-ip.com
21

Advertisement

Table of Contents
loading

Table of Contents