Genmega ATM Owner Quick Reference Manual page 8

ATM Quick Reference Guide
Next you'll be prompted to enter a password to
access the menu.
All passwords used to access this menu should be 6
characters. Default Master Password is 555555
If your ATM was programmed by someone else, then you
may need to get the password from your Distributor.
Press [ENTER] once you have entered the password.
NOTE If after pressing enter, you see a 'Select Service' menu – press ATM OP to continue.
Once you have entered the Operator Menu, depending on the password used, you'll have access to some of these
options below. You must have the 'Master Password' to have access to all functions:
If you do not see all the options above when entering the Operator Menu, then it just means that you're using a Service or
Operator Level password.
This would be normal as Master Password is only required for initial programming and setup.
To learn more about the menu functions above see the ATM AP Software Manual:
Genmega ATM Software Manual
http://ftp.genmega.com/Manuals/GenmegaAPManual.pd
QR-Guide 8 © Genmega 2024