Xerox Phaser 7760 Advanced Features Manual page 78

Setting the Default Punch Option
If the printer has a finisher, the Punch Option setting specifies the default for punching output.
Print jobs use the default punch option unless a different option is selected in the printer driver
when a job is sent to the printer.
To select the default punch option, use one of the following options:
■ The printer's control panel
■ CentreWare IS
Using the Control Panel
The factory default option for punching holes is Off. To select the default punch option on the
control panel:
1. Select
Printer Setup
2.
Select
Paper Handling Setup
3. Scroll to , select either
Punch
4.
If your finisher has a 2- / 4-hole punch installed, select
the OK button.
5.
If your finisher has a 3-hole punch installed, select
Using CentreWare IS
To select the default hole-punching option using CentreWare IS:
1.
Launch your web browser.
2. Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click Properties.
4. Select General on the left sidebar, and then select Printer Defaults.
5.
Select On from the Punch drop-down list to turn on hole punching. The default setting is
Off.
6. Select the appropriate hole-punching option from the Punch Holes drop-down list. The
default setting is 3.
7. Click the Save Changes button at the bottom of the page.
, and then press the OK button.
, and then press the OK button.
or , and then press the OK button.
On Off
Phaser® 7760 Color Laser Printer
4-17
Printer Settings
or , and then press
2 Holes 4 Holes
3 Holes , and then press the OK button.