Brady M210 User Manual page 902

Problem
Program
Invalid terminal repeat value
entered.
Error - "Cannot Fit"
Error - "Cannot Fit"
Error - "Cannot Fit"
"Cannot Fit" message received
while typing.
Left and right justification not
working.
Text not centered on label.
A large section of blank label
prints after text.
Cannot change location of the
human readable text in a
barcode.
Cannot add checksum character
in barcode.
M210/M210-LAB User Manual
Cause
The value entered is out of the
range.
Font size and settings too large
for label.
There are too many lines of text.
The maximum number of lines
allowed is four, but may be less
when using pre-sized labels.
Wrong label type or orientation
No more room on the label using
the font currently in use.
The printer currently does not
support left or right justification.
All label text will be center
justified only.
Possible blank spaces added to
text.
Possible blank lines added after
text.
The human readable text is
automatically added below the
label. This position is fixed and
cannot be changed.
The printer does not allow
checksum characters to be used.
Corrective Action
The acceptable range is between the
minimum of 0.2 inch (50.8mm) to the
maximum of 40 inches (1016mm).
• Change the font size to a smaller font.
(See page 34.)
• Delete some text.
(See page 33.)
A blank line is considered another line
of text. DO NOT press ENTER at the
end of a line if you DO NOT want
another line. (See page
• Select a different label type (e.g.,
banner landscape). (See
• Change orientation (vertical or
horizontal). (See page
• Check the label type. Sometimes
wiremarker or fixed length is
accidentally selected rather than
banner.
• Check that an additional line of text
was not inadvertently added.
No action required.
Press Clear
enter text.
Press Clear
enter text.
No action required.
No action required.
32.)
page 50.)
51.)
, then re-
, then re-
73