Table of Contents
Advertisement
8 electrolux
2.9:
• Duration of the set programme: after selecting a programme, the duration is dis-
played in hours and minutes (for example
cally on the basis of the maximum load for each type of fabric. After the programme has
started, the time remaining is updated every minute.
• End of programme: when the programme has finished three flashing zeros (
are displayed. The icon
• Incorrect option selection: if you set an option which is not compatible with the set
programme, the display shows the message Errfor a few seconds. The integrated red
light of button 8 starts flashing.
• Alarm codes: In the event of operating problems, some alarm codes can be displayed,
for example
• Delay Time value
2.10:
Soil degree icons: (see paragraph «Select Time Manager option»).
2.11:
Clock icon
icon is animated.
2.12:
Washing programme phase icons: when you set the wash programme, display shows
the phase icons corresponding to the various phases making up the programme. After
you have pressed button 8 only the icon of the running phase stays on.
• Prewash
• Wash
• Rinses
• Drain
• Spin
TABLE OF SYMBOLS
Programme selector dial
= Time Manager Programmes
Options buttons and lights
= Child Lock
= Time Manager buttons
+ / -
FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton
cycle at the highest temperature
PERSONALISATION
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• if there is a fault.
disappears. The door can be opened.
(see paragraph «What to do if...»).
: after the programme has started, the duration is displayed and the clock
(this icon lights on when the relevant option button is selected as well)
). The duration is calculated automati-
without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start the
machine.
By pressing the 5 and 6 buttons simultane-
ously for about 6 seconds, the acoustic
signal is deactivated (except if there is a
fault). By pressing these 2 buttons again,
the acoustic signal is reactivated.
)
Advertisement
Table of Contents
