Advertisement
Quick Links
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water properly.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly. Please check the
door!
If the appliance is
overloaded, remove
some items from the
drum and/or keep
pressed the door and
push the Start/Pause
button at the same time
until the indicator
stops flashing (see the
picture below).
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH
Advertisement
Related Manuals for Electrolux EWF1497HDW2
Summary of Contents for Electrolux EWF1497HDW2
-
Page 1: Troubleshooting
ENGLISH TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the Authorised Service Centre. With some problems, the acoustic signals operate and the display shows •... - Page 2 13.2 Possible failures Problem Possible solution The programme does Make sure that the mains plug is connected to the mains not start. socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box.
- Page 3 ENGLISH Problem Possible solution Make sure that the drain filter is not clogged. Clean the fil‐ ter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems.
- Page 4 After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre.