Regulatory/Compliance Information; Warranty, Service & Repair - HITEC RDX2 200 Operation Manual

REGULATORY/COMPLIANCE INFORMATION

FCC NOTE
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by unauthorized modifications or change to this
equipment. Such modifications or change could void the user' s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC's RF exposure guidelines, this equipment should be installed
and operated with a minimum distance of 20cm between the radiator and your body.
Hitec's RDX2 200 complies with FCC Part 15 Subpart B: 2019.
WARRANTY, SERVICE & REPAIR
LIABILITY EXCLUSION
This charger is designed and approved exclusively for use with the types of batteries stated in this Oper-
ation Manual. Hitec RCD USA accepts no liability of any kind if the charger is used for any purpose other
than that stated. We are unable to ensure that you follow the instructions supplied with the charger,
and we have no control over the methods you employ for using, operating and maintaining the device.
For this reason, we are obliged to deny all liability for loss, damage or costs which are incurred due
to any misuse or operation of our products. Unless otherwise prescribed by law, our obligation to pay
compensation, regardless of the legal argument employed, is limited to the invoice value of Hitec RCD
USA products which were immediately and directly involved in the event in which the damage occurred.
28
ONE YEAR LIMITED WARRANTY
For a period of one year from the date of purchase, HITEC RCD USA shall REPAIR OR REPLACE, at our
option, defective equipment covered by this warranty. Otherwise, the purchaser and/or consumer
is responsible for any charges for the repair or replacement of the charger. This warranty does not
cover cosmetic damages and damages due to acts of God, accident, misuse, abuse, negligence,
improper installation, or damages caused by alterations by unauthorized persons or entities. This
warranty only applies to the original purchaser of this product and for products purchased and used
in the United States of America, Canada and Mexico. Plastic cases are not covered by this warranty.
THIS WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES, WHETHER FOR MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE AND WHETHER EXPRESS OR IMPLIED. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY. HITEC RCD USA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY RELATING TO THIS PRODUCT, EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE ON THIS PRODUCT IS LIMITED TO THE DURATION OF THIS WARRANTY, REPAIR AND SERVICE.
THE RDX2 200 CHARGER WARRANTY IS VOID IF SOLD
AND/OR OPERATED OUTSIDE THE UNITED STATES.
NOTE
SERVICE AND REPAIR INFORMATION
To have your Hitec charger serviced:
1. Visit the Hitec website at HitecRCD.com and download the service request form.
2. Fill out the service request form completely and include a copy of your original receipt
showing the purchase date.
3. Package your product in its original packaging or use a suspension-type packaging (foam peanuts
or crumpled newspaper). Hitec RCD USA shall not be responsible for goods damaged in transit.
4. Ship prepaid (COD or postage-due returns will not be accepted) via a traceable common
courier (UPS, insured parcel post, FedEx, etc.) to:
Hitec RCD USA / Customer Service Center, 9320 Hazard Way, Suite D. San Diego, CA 92123
This symbol indicates that when this type of electronic device reaches the end of its service life, it cannot be
disposed of with normal household waste and must be recycled. To find a recycling center near you, refer to the
internet or your local phone directory for electronic waste recycling centers.
STATE OF CALIFORNIA PROPOSITION 65 WARNING
This product contains chemicals known to the State of California to cause cancer. Use caution when
handling this product and avoid exposure to any electronic components or internal assemblies.
This manual is subject to change without notice.
Please refer to the Hitec RCD USA website for the latest version.
HitecRCD.com
29