Advertisement
To Close Awning:
Pinch Hazard. When closing awning, bottom
arm will fold down and against back chan-
nel. This area must be kept clear of people
and objects. Failure to heed this warning
could cause severe personal injury and/or
property damage.
FIG. 2
1. Remote Rocker Switch (Located On
The Power Supply)
a. Press and hold the "Retract" but-
ton to automatically close aw-
ning. If the button is released the
awning will stop. Maintain button
depressed until awning is fully re-
tracted, then release.
Important:
As an extra safety precaution, visually
verify that the awning is fully closed.
To Adjust The Awning Pitch:
1. Lower the roller tube for more shade, as the sun
sets. With awning fully extended, loosen knob on
bottom arm.
Pinch Hazzard. When adjusting awning
pitch, bottom arm will telescope. Keep hands
and objects clear of openings around bot-
tom arm. Failure to heed this warning could
cause personal injury.
2. Pull top arm down to lower roller tube to desired
height.
3. While holding top arm in place, tighten knob to
set pitch.
4. Repeat for hardware on other side.
Important:
Pinch
ensure that one end of the awning is lower than the
Point
other end. This will reduce the potential for water pool-
ing in the center of the awning. See FIG. 4.
Pinch
Point
EXTEND
RETRACT
In Case Of Awning Power Failure Or To
Important:
When this procedure has been performed, the awning
must be serviced.
There is a method of rolling up the awning
if it appears there is no power to the awning
motor. The following method should be
performed:
3
Residential Patio Awning User's Guide
Arm Down
FIG. 3
To ensure rain water will run off awning,
5. Prior to closing awning, loosen knob to allow aw-
ning to reset to original position. Lightly tighten
knob.
FIG. 4
Manually Close Awning:
This procedure will require two people.
1. Slide the pull strap (provided) into the utility slot of
the FRTA. FIG. 6
2. While one person is holding onto the pull strap,
remove the screw in the top of the right top cast-
ing. The FRTA will immediately roll in once the
bolt is removed. Walk the awning to the closed
position.
3. Align hole where screw was removed and replace
screw into top casting to secure awning.
Pull Top
Then
Tighten
Knob
Advertisement
