Media For The Micr Fonts; Micr Fonts Installation; Installing Postscript And Pcl Fonts - Xerox DocuPrint 100 User Manual

Media for the MICR fonts

MICR fonts installation

Installing PostScript and PCL fonts

MICR User Guide
MICR Fonts CD-ROM
The PostScript, PCL, and LCDS MICR fonts are provided
on two CD-ROMs—one for 300 dpi printing and one for
600 dpi and above. The two CDs contain the same fonts
except for the following:
·
The 600 dpi MICR Fonts CD contains the E13B9 and
E13B PostScript 600 dpi fonts.
·
The 300 dpi CD contains a 300 dpi version of the
E13B PostScript font. It does not contain E13B9,
which is 600 dpi only.
Note: When loading your fonts from CD, load the fonts
from either the 600 dpi MICR Fonts CD or the 300 dpi
CD. If both versions of the 9.12 point E13B PostScript
font are present on the system at the same time,
unpredictable results can occur. For this reason, two CDs
are provided, each containing a different version of the
9.12 point E13B PostScript font.
If you have loaded your MICR fonts from the 600 dpi CD
and you want to print using the 300 dpi PostScript MICR
font, you must first delete the 600 dpi E13B.PFB font, then
reload the 300 dpi E13B.PS font from the 300 dpi CD.
If fonts were loaded from the 300 dpi CD, delete the 300
dpi E13B.PS font before loading the 600 dpi E13B.PFB
font. (Refer to "Installing PostScript and PCL fonts," later
in this chapter, for the font loading procedure.)
Media for IPDS fonts
AFP MICR fonts, supporting the IPDS datastream, are
provided at 300 dpi on various media (CD, cartridge tape,
or diskette). Follow instructions for your host system for
loading these fonts on the host.
To install the PostScript and PCL fonts, follow these
steps.
1. Log in at the Administrator level.
2. Insert the "DocuPrint MICR Fonts" CD into the CD-
ROM drive.
3. Click the Administration icon on the main DocuSP
window.
MICR fonts
2-3