Spraying Technique; Breaks In Work - Titan CAPSPRAY X 80 Operation Manual

SPRAYING TECHNIQUE

6
SPRAYING TECHNIQUE
Hold the paint spray gun upright and maintain a constant distance of
about 3 - 20 cm to the object being sprayed.
Move the paint spray gun evenly either from side to side or up and
down. If the gun is moved evenly, it will produce an even surface finish.
No runs will occur if the speed is correct.
Always start spraying away from the object and avoid stopping
spraying whilst still on the object.
If the round jet setting is used, the distance may be
i
increased according to the size of the object being
sprayed.
•
In case of excessive paint mist formation, adjust the air and material
flow respectively and alter the distance from the object.
RIGHT
3 - 20 cm
WRONG
Excessive paint mist formation, uneven surface finish.
8
6.1

BREAKS IN WORK

1.
Turn the material control knob to the right as far as it will go (fig.
17).
This will secure the paint spray gun against unintentional
operation.
2.
Switch the unit off.
CAPSPRAY X 80