Introduction; Components - Titan CAPSPRAY X 80 Operation Manual

SAFETY PRECAUTIONS / INTRODUCTION
WARNING: SKIN BURN INJURY
Heated parts can cause severe skin burn injury.
PREVENTION:
•
Quick disconnect fittings on the hose and spray gun become hot
during use. Avoid skin contact with quick disconnect fittings
when they are hot. Allow quick disconnect fittings to cool before
disconnecting the spray gun from the hose.
2

INTRODUCTION

This High Volume/Low Pressure (HVLP) spray system is designed for
applying coatings to surfaces that can be sprayed faster than brushing
or rolling and are too small for traditional airless sprayers.
Components of this system include a power switch, a power cord, a
filter warning light, a circuit breaker switch, a dual filtration system, a
cup holder, an air hose, and an air outlet.
The turbine is also equipped with a tool box. It is located on the top of
the turbine and can be used to store projector sets or any other small
spare parts.
Some of the graphics in this manual may not exactly
i
match your turbine and spray gun. All information
and instructions given in this manual applies to all
models except where noted.
With this HVLP spray system, you can achieve the highest quality
professional finish possible with little or no preparation or setup time.
Please review all the information contained in this manual before
operating the system.
19
20
21
22
23
4
2.1
COMPONENTS (FIG. 1)
1 Spray gun assembly
2
Air cap ring
3
Air cap
4 Fluid inlet
5
Check valve
6 Cup locking lever
7 Swivel tube lever
8
Cup seal
9 Suction tube
10 Container
11 Air flow adjustment
12 Material flow adjustment
13 Trigger
* The air filter indicator will light up red if the main filter is
blocked.
** The auxiliary air filter can be found under the cover on the
other side of the turbine
15
16
17
18
24
14 Air hose
15 Carry handle
16 ON/OFF switch
17 Air filter indicator*
18 Air hose connection
19 Storage compartment
20 Gun holder
21 Main filter housing**
22 Power cord clamp
23 Power cord
24 Fine feed filter (red)
25 Course feed filter (white)
26 Cleaning brushes
26
11
12
13
14
25
CAPSPRAY X 80
1
2
3
4
5
6
7
8
9
10