Installer Setup; Setting Up Remote Control - Crawl Space/Sealed Attic; Setting Up Ventilation/Air Cycling; Applying An Rh Offset - Aprilaire E070 Installation & Owner's Manual

INSTALLER SETUP

Enter the setup menu if:
• remote control will be used
• ventilation/air cycling will be used
1. Plug unit in and turn the power switch ON (if equipped)
2. The onboard control screen should display OFF. If not OFF,
press the ON/OFF button to turn the unit OFF.
NOTE: If the display backlight is not on, the first button press
(any button) will only turn on the backlight. Press the button a
second time to achieve function�
3. Hold the MODE button on the onboard control for 3 seconds
to enter the installer setup menu�
4. Navigate through the following screens to set up the
dehumidifier for the installed application.
5. Use the s or t button to select items and use the MODE
button to switch to the next setup option. To exit the installer
setup, scroll through all options using the MODE button.
6. After the installer setup options have been completed, the
word DONE will blink for 3 seconds and the control will return
to the OFF screen�
10
English
SETTING UP REMOTE CONTROL – CRAWL SPACE/ SEALED ATTIC
If wiring to a Model 76 for remote control (see page 9 for details)
press the s or t button to ENABLE�
SETTING UP VENTILATION / AIR CYCLING
1. If using the dehumidifier for air cycling (see page 9 for
details) press the s or t button to ENABLE then press the
MODE button.
90-1854
2. Press MODE at the VENT TIMED screen to go to ventilation
time selection screen�
3. Press the s or t arrows to adjust the ventilation time per
hour from 0 to 60 minutes�

APPLYING AN RH OFFSET

An offset can be applied to the onboard humidity reading to
avoid discrepancies with other humidity-measuring devices in
the home� Use the s or t button to select an offset from -5% to
5%. Press the MODE button to exit the installer setup screens.