Cleaning The Imaging Area; Running A Transport Cleaning Sheet - Kodak i1150 Series User Manual

Cleaning the imaging area

Running a transport
cleaning sheet
4-8
1. Wipe the upper and lower imaging area using a Brillianze Detailer
wipe (Step 1) or Staticide wipe. Be careful not to scratch the
imaging area when cleaning.
IMPORTANT: Staticide wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the MSDS for more information.
2. Wipe the upper and lower imaging area again using a Brillianize
wipe (Step 2) or an almost dry Staticide wipe to remove any streaks.
3. When finished, close the scanner cover.
In addition to regular cleaning procedures, you can run a transport
cleaning sheet. Transport cleaning sheets are available for purchase.
See the section entitled, "Supplies and Consumables" later in this
chapter for more information.
1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the side guides to fit the cleaning sheet.
3. Place a transport cleaning sheet in the input tray (adhesive side
facing you) in portrait orientation.
4. Using your scanning application, scan the transport cleaning sheet.
5. After the transport cleaning sheet is scanned, turn it over (adhesive
side facing the input tray) and scan it again.
6. Open the scanner cover and wipe the imaging area with a lint-free
cloth.
7. Close the scanner cover.
8. Check your image quality.
9. If necessary, repeat this procedure until all residue is removed from
the rollers.
NOTE: When a transport cleaning sheet gets very dirty, discard it and
use a new one.
A-61816 January 2016