Other Functions - Mitsubishi Electric Mr.SLIM PUHZ-P140VKA Operation Manual

7. Other Functions

 /RFNLQJ WKH 5HPRWH &RQWUROOHU %XWWRQV 2SHUD-
WLRQ IXQFWLRQ OLPLW FRQWUROOHU
If you wish, you can lock the remote controller buttons. You can use
the Function Selection of remote controller to select which type of lock
to use.
(For information about selecting the lock type, see section 8, item [2]
  6SHFL¿FDOO\ \RX FDQ XVH HLWKHU RI WKH IROORZLQJ  ORFN W\SHV
1 Lock All Buttons:
Locks all of the buttons on the remote controller.
2 Lock All Except ON/OFF:
Locks all buttons other than the ON/OFF button.
Note:
7KH ³/RFNHG´ LQGLFDWRU DSSHDUV RQ WKH VFUHHQ WR LQGLFDWH WKDW EXWWRQV DUH
currently locked.
 (UURU &RGHV LQGLFDWLRQ
If you have entered contact number to be called in the event of a problem, the screen displays this number.
(You can set this up under Function Selection of remote controller. For information, refer to section 8.)
If the ON lamp and error code are both blinking: This means that the air conditioner is out of order and operation has been stopped (and cannot re-
sume). Take note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer.
ÛC
If only the error code is blinking (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the system. In this case,
you should note down the error code and then call your dealer or servicer for advice.
* If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen. (You can set this up
under Function Selection of remote controller. For information, refer to section 8.)
Downloaded from www.Manualslib.com
TIME SUN
FUNCTION
ÛC
ÛC
TEMP. ON/OFF
CLEAR
When the Check button is pressed:
ERROR CODE
ÛC
ON/OFF
Error Code
manuals search engine
<How to Lock the Buttons>
1. While holding down the Filter button 4, press and hold down the ON/
OFF button 1 for 2 seconds. The "Locked" indication appears on the
screen (at 1), indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote control-
ler, the screen will display the "Not Available" message when you
press the buttons as described above.
‡ ,I \RX SUHVV D ORFNHG EXWWRQ WKH ³/RFNHG´ LQGLFDWLRQ DW 1) will blink
on the display.
1
Lock Indicator
<How to Unlock the Buttons>
1. While holding down the Filter button 4, press and hold down the ON/
OFF button 1 for 2 seconds—so that the "Locked" indication disap-
pears from the screen (at 1).
1
4
Indoor Unit's Refriger-
ant Address
p
CALL:XXXX
XXX:XXX
ON/OFF
1
FUNCTION
ÛC
ÛC
1
FUNCTION
ÛC
ÛC
1
ÛC
ÛC
ERROR CODE
ON/OFF
Error Code Indoor Unit No.
Alternating Display
ON lamp
(Blinking)
11