Table of Contents
Advertisement
ice-route 8 sec. after initial power on.
2. Check whether Hinge-up connector contact is normal.
ith the intial power on,
does MICOM #18 on PCB indicate HIGH"
state for 0.3se0.?
No defect on S/V control PCB ASS'Y
and wire system
MICOM control port is normal
Check and repair
devices such as
stopper lever &
support, etc
hen ice lever.is
pressed, does it maintain
the point
inital power on, does 1003 ut indicate "LOWE
sale for 0.350?
Check ICE SW.
Advertisement
Table of Contents
