Advertisement
INSTALLATION
If your Silver King unit has a stainless steel exterior it has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm,
mild soapy water solution and a sponge or cloth.
Lid
For shipping purposes the Lid Assembly has been taped to the cabinet. Remove all the tape from the Lid Assembly and install the Lid
Assembly on the cabinet by holding in the hinge pins at the back of the Lid Assembly and inserting them into the holes in the Hinge
Brackets on the cabinet.
LOCATION
When locating your countertop drop-in display merchandiser, convenience and accessibility are important considerations, but the
following installation guidelines must be followed;
•
When installed in a countertop, provisions need to be in place for the unit to receive proper ventilation for the compressor. The
drawing on the opposite page shows minimum ventilation requirements for the unit. Do not install the unit in cabinetry that does not
have provisions for ventilation as that would void all warranties.
•
Always avoid placing the unit next to an oven, heating element or hot air source that would affect the operation of the unit.
•
The unit must be level.
•
The counter must be able to support a minimum of 150 pounds.
•
See installation diagram on the next page.
Safety
Do not store explosive substances such as aerosol cans with a flammable propellant inside the appliance.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate
the manufacturers responsibility, and could result in serious injury.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard."
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
Energy Rating
Your Silver King refrigerator has a class 4 energy rating. The refrigerator was tested at an ambient temperature of 40°C at 40% relative
humidity.
2
Advertisement
