Finishing Options - Xerox DocuColor 242 Release Note

Page 17
Page Range
You cannot access the Page Range option from the printer driver. Use the application page
range option or change the setting for this option in Command WorkStation.
Layout (N-up Layout) and Print Page Borders
If you print an N-up job, where N is greater than 1, from the PCL printer driver, you can
control whether the borders of the pages are printed, using the Print Page Borders option.
If you print from the PostScript printer driver, page borders are always printed.
Offset Mode and Page Size
If you enable Offset Mode (Finishing tab) for your print job, do not select A5 LEF and B5
SEF as Page Size

Finishing Options

Stapler Mode and Punch Position
Stapling and punching require that a finisher is installed on the copier. The finisher type
determines the number of holes (2, 3, or 4) punched. Use the Punch Position print option to
specify the position of punching. Use the Stapler Mode print option to specify the number
(1 or 2) and position of staples.
Finishing Options on the Advanced or Professional Finisher
Neither stapling nor punching are supported for the following page sizes on the Advanced or
Professional Finisher:
4 x 6 SEF, 5 x 7 SEF, A5 SEF, A5 LEF, B5 SEF, 12 x 18 SEF, SRA3 SEF, 13 x 19 SEF
For which stapling and punching options are available for each supported page size, see the
following tables.