Advertisement
SRF-M903
Radio Operation
'D)
1 Connect the earphones.
Extend the cord as it serves as the FM
antenna.
2 Press AUTO OFF/POWER to turn on the
power.
The dispiay window shows a frequency.
Select FM or AM with BAND.
Tune in the desired station by pressing
TUNE/TIME SET +/- button.
At each press of +, the FM frequency
becomes 0.05 MHz higher (the display
changes by 0.1 MHz) and the AM
frequency becomes 9 kHz higher. At each
press of -, the FM and AM frequencies
become
lower by the same
intervals.
To change the frequency rapidly, keep the
button pressed.
Adjust VOLUME.
aw
a
To turn off the radio
Press AUTO OFF/POWER again.
The display shows the current time.
When the power is turned off
automatically
The radio will be turned off automatically in
about 90 minutes to prevent unnecessary
wear of the batteries.
To continue listening to the radio, press
AUTO OFF/POWER again. If the batteries
are exhausted, the power is turned off
automatically to protect the preset contents.
Memory Preset Tuning
Once you store the desired stations, you can
tune them in by a simple operation. You can
store 7 stations for each of the FM and AM
bands.
How to Preset 'E|
1 Turn on the power.
2 Tune in the desired station to preset.
See 'Radio Operation"'.
3 Keep ENTER/CLOCK pressed for more
than 1 second.
Release ENTER/CLOCK when PRESET
and a preset number indicator flash in the
display window with the beep sound.
4 Select a preset number from 1 to 7 by
pressing MEMORY
PRESET
+/-
button.
Press
+ to increase
(1727
....
76-7)
the digit
et
——
Press
~
to decrease (7~6-—
.
. 72-1)
the digit.
Sei
5 Press ENTER/CLOCK again.
Beep-beep sounds, and PRESET
and a
preset number stop flashing. The station
has been stored.
To preset other stations, repeat steps 2 to
5.
Note
Go to the next step while the PRESET and
preset number are flashing (for about 5
seconds). Otherwise the unit returns to step
2. If this happens, try again from step 3.
To Tune in a Preset Station
LF
1 Turn on the power.
2 Select the band, FM or AM.
3 Select the desired preset number by
pressing MEMORY PRESET
+/-—
button.
4 Adjust VOLUME.
To change the preset station
Tune in the desired station to be newly
preset. Preset the tuned station to the
desired button. The station previously preset
to the button is lost.
For Better Reception
FM [G|
Extend the earphone cord so that the FM
sensitivity will be increased, as it serves as
the FM antenna.
AM [H|
The ferrite bar antenna is built in for AM
reception. Rotate the unit horizontally for
optimum reception.
If the FM stereo program is noisy
Usually set ST/MONO to ST. You can
receive the FM stereo program in stereo.
When the signal is weak and noisy, set to
MONO. There will be no stereo effect, but
the sound will improve.
Advertisement
