Section 2 Service Note; Operation Notes; Flexible Board; Fine-Wire Coaxial Cable - Sony ZV-1 Service Manual

2-1. Operation Notes

2-1-1. Flexible Board

• Make sure that the conductive side of a flexible board does not have any stain or foreign materials.
• Do not touch the conductive side of flexible boards with bare hands.
• Plug in a flexible board straight, fully into the connector until it reaches the end inside.
OK
(The flexible board was plugged in
straight and completely)
Flexible
Board
Reference line
Connector Connector
• When opening the connector's holder in direction A, do not open it with excessive force.
Holder
A
Connector
A
Flexible Board
• When closing the connector's holder, press it evenly while pushing a flexible board in direction B.
Holder
Connector
Flexible Board
B
Insulation side
• Make sure that the flat cable and flexible board are not cracked or bent at the contact end.
• Do not apply excessive force to the gilded flexible board.

2-1-2. Fine-Wire Coaxial Cable

• The proper way to disconnect a connector is to grab the connector instead of the wires. If you pull on the wires, they might be
broken.
• The proper way to connect a connector is to grab the connector instead of the wires. If you push on the wires, they might be
broken.
Section 2
Service Note
NG
(The flexible board was plugged in
crooked.)
Flexible Flexible
Board
Board
Reference line
Connector Connector
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
NG
(The flexible board was not plugged in
completely.)
Flexible
Board
Reference line
Flexible
Board
Connector Connector
Sony CONFIDENTIAL
For Authorized Servicer
Flexible
Board
7
SYS SET