Service Note; Method For Copying Or Erasing The Data In Internal Memory - Sony Cyber-shot DSC-W580 Service Manual

1-1. Notes on Using Tripod Adaptor
This model uses a Tripod Adaptor for adjustments.
When using a Tripod Adaptor, alter the USB, A/V cable for multi-use terminal as shown in the figure below.
1-2. PRECAUTION ON REPLACING THE SY-274 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the "DESTINATION DATA WRITE".
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "RESTORE DATA" to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
• Angular Velocity Sensor Sensitivity adjustment
• AWB standard data input & check, Color reproduction check
Note: When you cannot read data from the former replace the same time SY-274 board and lens.
Regarding the PMB Portable
PMB Portable has been written in internal memory.
SY-274 board for service is supplied with written the PMB Portable.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the "USB SERIAL No. INPUT".
Angular Velocity Sensor
When you replace to the reparing board, write down the sensitivity displayed on the angular velocity sensor (SE401).
Start the Adjust Manual in the Adjust Station and execute the "Angular velocity sensor sensitivity adj".
SY-274 BOARD (SIDE B)
PPP: PITCH sensor
sensitivity
SE401
PP
YY YYY: YAW sensor
sensitivity
Note: The sensor sensitivity of SE401 of SY-274 board is written only repair parts.
DSC-W580_L2

1. SERVICE NOTE

1-3. METHOD FOR COPYING OR ERASING THE DATA IN INTERNAL MEMORY

The data can be copied/erased by the operations on the HOME screen. (When erasing the data, execute formatting the internal memory.)
Note 1:When replacing the SY-274 board, erase the data in internal memory of the board before replacement.
Note 2:When replacing the SY-274 board, execute formatting and initialize the internal memory after replacement.
Method for Copying the Data in Internal Memory
Copy
Copies all images in the internal memory to a memory card.
1. Insert a memory card with sufficient free capacity into the camera.
2. MENU (Settings)
Notes
Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little
remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the
data.
Images cannot be copied individually.
The original images in the internal memory are retained even after copying. To delete the
contents of the internal memory, remove the memory card after copying, then format the internal
memory ([Format] in [Internal Memory Tool]).
A new folder is created on the memory card and all the data will be copied to it. You cannot
choose a specific folder and copy images to it.
Method for Formatting the Internal Memory or "Memory Stick Duo" media
Format
Formats the memory card or the internal memory. When you use a memory card with this camera for
the first time, it is recommended to format the card using the camera for stable performance of the
memory card before shooting. Note that formatting permanently erases all data on the memory card,
and is unrecoverable. Save precious data on a computer, etc.
1. MENU (Settings)
[Format] [OK]
Note
Note that formatting permanently erases all data including even protected images.
1-1
(Memory Card Tool) [Copy] [OK]
(Memory Card Tool) or (Internal Memory Tool)
– ENGLISH –