Step 3: Secure the outdoor unit
3. Place the outdoor unit on the stand.
4. Secure the holes in the feet of the outdoor unit with the bolts.
Step 4: Connect the pipes of the outdoor unit and the indoor unit
5. Remove the screw on the cover to the right of the unit and remove the cover.
6. Remove the screw cap and point the joint to the tube bell.
7. Pre-tighten the nut by hand.
8. Tighten the nut with a torque wrench referring to the table below.
MUI_N-SMVHxxB-xA2A3NG(O)_Ita_Eng_Fra_Deu_Neutro/Rev.00/Data 08.07.2020
Pipe joint
Liquid valve
Gas valve
Nut
35
Cover
ENGLISH
ENGLISH
35