Table of Contents
Advertisement
Available languages
Available languages
Auto/Manual Ranging Mode (
)
The meter defaults to autoranging mode when powered on. In this mode, the meter
automatically selects the best range to display the measurement. By pressing the
Range (
) button on the meter, the manual range mode will override the auto-
ranging feature of the meter. A (
) appears in the upper left side of the display.
Continue pressing the Range button until the desired range is obtained. Use this
mode to lock in a specific range for repeated measurements. To return to the
autoranging mode, either depress the Range button for greater than 1 second or turn
the meter off and then back on again.
Data Hold Feature
Press the Hold button on the side of the meter to toggle in and out of the data hold
mode. "HOLD" appears in the upper left of the meter display when data hold is
active. Use the data hold feature to lock a measurement reading on the display. Press
the Hold button again to unlock the display and obtain a real-time reading.
Auto Power Off (APO) Feature
The meter automatically powers itself down after about 10 minutes of no use. Press
any button, and the meter will wake up and display the last reading taken before
power down. This feature can be overridden by holding the Range (
) button while
turning the function switch from Off to any other position. When APO is defeated, the
"APO" will be removed from the display. Turning the meter off will restore the APO
default.
Page 6
Advertisement
Table of Contents
