Page 1
[2] Connect one end of the optical cable (Toslink) to the input port (Digital receiver, digital speakers). Connect the opposite end to the CPLCT device. [3] Connect the power supply to the CPLCT. A red pilot indicates the CPLCT is active for use. 08905096A...
Page 2
[5] Connect the power supply to the CPLTCX. A red pilot indicates the CPLTCX is active for use. [6] Connect the power supply to the CPLCT. A red pilot indicates the CPLCT is active for use. [7] System is now ready for use.
Page 3
Connect the opposite end to the output port of the CPLCT device. [4] Connect one end of the long distance coaxial cable to the input port of the CPLCT device. [5] Connect the power supply to the CPLTCX. A red pilot indicates the CPLTCX is active for use.
Page 4
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document. 08905096A Xantech Corporation...