Xantech RMZPR Installation Instructions

RACK MOUNT ADAPTER FOR THE ZPR68-10
STATUS
1
2
3
4
5
6
Fig. 1 The RMZPR, Front View
The RMZPR provides a convenient means for mounting the ZPR68-10 Six Zone Eight Source Remote
Preamp into a standard 19 inch rack. It incorporates six STATUS LED's that indicate zone ON/OFF
condition. The black anodized panel is a standard 8.75 inch increment height and is 3/16" thick. Install the
panel as follows:
1. Mount the ZPR68-10 to the rear of the RMZPR. Refer to Fig. 2 below. Use the hardware that comes
with the ZPR68-10 and the RMZPR.
2. Plug the 10-lead connector of the ribbon cable into the mating 10-pin connector on the ZPR68-10.
Be sure to orient the connector so that the red stripe on the cable is positioned as shown in
Fig. 2!
NOTE: The LED's will not work with the ZPR68-00.
3. Mount the completed assembly into a 19" rack using the rack panel cup washers and screws supplied.
See Fig. 2 on next page.

INSTALLATION INSTRUCTIONS

RMZPR
ZPR68
SIX ZONE EIGHT SOURCE REMOTE PREAMP

1