Panasonic DOUBLEFEATURE Omnivision PV-D4743 Operating Instructions Manual page 4

Congratulations
on your purchase of one of the most
sophisticated and reliable products on the
market today. Used properly, it will bring you
years of enjoyment. Please fill in the
information below. The serial number is on the
tag located on the back of your DECK.
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
• Model No
• Serial No.
[] Remote Control
LSSQ0374 (PV-D4743)
LSSQ0375 (PV-D4743S)
'@
[] Batteries 2 "AA"
[] RF Coaxial Cable
LSJA0372
jJ
J
To order accessories, call toll free
t-800-332-5368.
Disc formats supported by this DECK
DECK can play back discs bearing any of the following
marks: [Discs Played 8cm (3") or 12cm (5")]
Logo Disc type
DVD (DVD-Video)
DVD-R (DVD-Video formatted
_. discs [finalized])
_]_ Video CO
CD (CD-DA)
_]_'_ CD-R/CD-RW (CD-DA,Video CD
MmtL_
formatted discs [finalizedj,
WMA_ MP3_ JPEG
Discs which cannot be played
• DVD with Region No. other than "1" or "ALL'
• DVD of PAL system, DVD-Audio, DVD-RAM, DVD-ROM,
DVD-RW, DVD+RW, CD-ROM, CDV, CD-G, CVD, SVCD,
SAC[:), Divx Video Disc and Photo-CD
O
• Do not use irregularly shaped discs (e.g. heart-
shaped), as these can damage the unit.
• It may not be possible to play CD-R, CD-RW and
DVD-R in all cases due to the type of disc or
condition of the recording.
Handling precautions
• Sticking a label on the disc may impair DVD-R
playback.
• Do not attach sticker to discs. (Do not use discs
with exposed adhesive from tape or left over
peeled-off stickers.)
• Only hold disc by edges as shown below.
Fingerprints, dirt and scratches can cause skipping
and distortion.
• Do not write on label side of disc.
• Never use record cleaning sprays, benzine, thinner,
static electricity prevention liquids, or any other
solvent.
_ j l)Opencover.
2) marked,insert batteries as
3) Close cover.
[] Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese
batteries.
• Do not try to close disc tray when disc V
is not properly placed.
To clean disc surface O
With a soft, damp (water only) cloth,
gently wipe from the center hole to the (" _ZZ)-*_
outer edge as shown below. (Wiping in a
circular pattern will scratch the surface.) X
If disc is brought from s cold to a
warm environment, moisture may
form on the disc
Wipe away moisture with a soft, dry. lint-free cloth
before using disc. (See above.)
Improper disc storage
Discs could be damaged if stored or left in areas:
• exposed to direct sunlight,
• that are humid or dusty.
• near heat (i.e. heater, radiator, etc.).
4