Advertisement
Chapter 1
2)
=
77)
>
ra
ra)
Cupwheel
- Printing Element
8 Hold the Knob of the Cupwheel Printing Ele-
ment and turn it slightly to check that it rotates
freely.
9 Slide the Bottom Cover Lid to its closed position.
y| 0 Before setting the POWER
Switch to "ON",
confirm that the Cupwheel Printing Element has
not been caught by the Ribbon.
If the Element has been caught, remove
the
Ribbon Cassette and install it again.
Refer to pages 10 and 11.
eSet the Pitch in accordance
with the type of
Cupwheel Printing Element.
If the power is switched on while the Cupwheel
Printing Element is incorrectly installed, the buzzer
will sound.
In this case, set the POWER
Switch to "OFF" and
install the Cupwheel Printing Element correctly.
[s|
Advertisement
