Advertisement
Typing may now proceed...
I * Verify that the Cupwheel
Printing Element,
Ribbon Cassette and Correction Tape are cor-
rectly installed.
1 Press the MODE Key to
MODE
make the following mes-
sage appear on the LCD
ae
Display. (It may be neces-
sary to press the MODE
Key more than once.)
zZ Connect the AC Power Cord to the Power Input
Jackin
the unit and household AC Socket.
Refer to page 7.
wo
>
2
Oo
ie)
u
m
ps
>
=
1°]
z
7)
2
Try typing the following
word:
3 Set the POWER Switch to the "ON" position.
The Carriage will initialize and move to the left
typewriter
margin that was last set.
elf the Carriage is on the right side (immediately
after removing the Packing Stopper or replac-
ing the Cupwheel Printing Element, etc.), a
mechanical
noise will occur.
This is not a
problem.
Refer to page 7.
The characters have now appeared on the paper as:
4
Insert the paper under the back of the Platen and
rotate the Platen Knob to feed the paper to the
The Typing of one character at a time onto the paper
desired position.
is called the Typewriter (TPWR) Mode.
You now know how to proceed with simple typing.
Read through the following description in order to
make full use of the unit's functions.
If the operation is interrupted and/or the buzzer
sounds continuously turn the unit.off and then on. If
the unit does not return to normal operation and/or
the buzzer still sounds check to see if the Ribbon
Cassette or the Correction Tape.has reached its end.
Advertisement
