Advertisement
Appendix
No operation
| POWER Switch on "OFF".
Set the POWER Switch to "ON".
even when keys [ "EXT" Mode.
Exit the External Mode.
pa
are pressed.
Nothing
appears
spe
The LCD Contrast Adjuster is set to
low contrast.
on the LCD
Display.
Paper Release Lever is in Release
Push lever to Lock position.
position.
End of Ribbon Cassette.
Replace with new Ribbon Cassette.
|
10~11
Typing impression is too soft.
Increase typing impression
Correction Tape is not installed or has
been used up.
Adjust the setting of the LCD Contrast
Adjuster.
Unit does not
print correctly,
or printing is
blurred.
No deletion even
with (X] Key;
blurred
characters.
Install Correction Tape or replace with
new one.
Press the RETURN Key and move the
Carriage to next line.
Press the MAR REL Key and continue
16
printing on same line.
Y
Re-edit the data or cancel the Text
Text Memory is full.
Memory Mode.
All Reset
Turn the POWER Switch "OFF" once,
then back "ON" again.
If the unit still does not function
properly, press the TAB CLR Key and
<x]Key simultaneously while pressing
the CODE Key.
At this time the Text Memory, Margin,
Tab, etc., are all cleared.
Buzzer sounds
during typing
and typing is
disabled (keys
do not function).
Carriage.at right margin.
The main unit
does not operate
properly or the
mechanism error
buzzer sounds
continuously.
Noise on the AC line or static
electricity may prevent the main unit
from operating properly.
When the buzzer
sounds, a
Re-install the Cupwheel Print Element.
p89 |
cease to operate.
"C-ERR" appeared on the LCD
Check to see if there is any foreign
Display.
matter in the Carriage mechanism.
APPENDIX
Advertisement
