Table of Contents
Advertisement
Convertible Sofa
To convert the sofa into the bed position, pull forward on the top of the
sofa back (A). As the sofa back comes forward, grasp it at the bottom
and rotate the seat back until it reverses (B) and lays flat next to the
sofa seat (C). Repeat this process on the sofa on the other side of
the RV. Set the sofa lock mechanism to the "LOCK" position (D) This
locks the sofa into the bed position.
A
B
Sofa Lock - Released
To convert back into the sofa position, reverse the process.
The bed must be fully lowered to convert it into the sofa.
Lowering both Beds
Press "Down" on the Bed Lift Switch
Control. Both beds will lower together
until the upper bed reaches the pre-set
stopping point. The bottom convertible
sofa continues lowering until it also
reaches a pre-set stopping point. Make
sure to lower the sofa legs before
bringing the convertible sofa to the
bottom position.
Raising the Beds
Before raising the beds, set the lock levers on each rail to the "Lock
Bunk" down position. You MUST set all 4 levers.
Lock Levers
Press "Up" on the Bed Lift Switch Control until the top bunk reaches
the maximum height and locks into place. When raising the beds, the
bottom bed will rise until it meets the upper bed, then both will rise to
the highest point.
Page 94
C
D
Sofa Lock - Locked
Adjustable Sofa Leg
Lock Level Positions
"Lower Bunk"
"Lock Bunk"
Up Position
Down Position
INTERIOR
Once the upper bunk is locked into place, you can leave both bunks
in this position (be sure to lock the sofa legs in the up position), or you
can lower the lower Convertible Sofa independently for use leaving
the upper bunk at the top (make sure the sofa legs are down). See the
Convertible Sofa section above to prep the sofa.
Lowering the Upper Bunk for Use
Make sure the Convertible Sofa is in the bed configuration. Set the 4
lock levers on each rail to the "Lower Bunk" up position. Press "Up"
on the Bed Lift Switch Control until the Convertible Sofa reaches and
unlocks the upper bunk. Continue by following the "Lowering Both
Beds" section above.
There is an emergency manual override which allows the beds to be
lowered or raised manually in the event the motorized lift becomes
in-operative.
Refer to the manufacturers' bed-lift user manual for additional
information regarding upper bunk operation, stowing, manual override
feature, and troubleshooting.
Storing the Sofa on the Wall
In case you need additional width in the cargo area, the Convertible
Sofa can be stored against the sidewalls.
This procedure is easiest to perform with 2 people and the back door
open.
1.
Make sure the sofa is in bed configuration, and the upper bunk is
at it's maximum height.
2.
Press 'UP' on the Bed Lift Switch Control to raise the Convertible
Sofa at least 5' from the floor.
3.
Insure the Sofa Lock is in the Locked position.
4.
With 1 person on each end of
a sofa seat, remove the locking
pins (E) on each side. The seat
should not immediately drop, but
for safety support the seat with
one hand as you remove the pin
with the other.
5.
Lift the seat from both sides, and
pull slightly away from the wall.
6.
Lower seat to the sidewall
7.
Replace locking pins (so they don't get lost)
8.
Repeat for the other side.
Reverse the above procedure to put the sofa back in seating position.
(See page 97)
Locking
Pin
E
Advertisement
Table of Contents
