E69: Washing Heating Element Damaged - Electrolux EWM0931 Series Service Manual

E69
Checks to perform:
Measure the resistance
value of the heating
element (Ω) between
terminals J6-1 - J6-2 of the
wiring connector
-(see fig. 4)-
Is the value correct?
(28-31Ωfor 230V/1750W)
Y
E
S
Replace the circuit board
and repeat the diagnostic
cycle to check for any
further alarms.
Fig.13
28÷31Ω 230V 1750W
2010 SOI/DT-mdm FCPD-dp Quality-tb
Guide to diagnostics for electronic controls EWM0931x

E69: Washing heating element damaged

Check that all the connectors are inserted correctly
Measure the resistance
value directly on the
terminals of the heating
(detach the connectors)
NO
- (see fig 13) -
Is the value correct?
(28-31Ωfor 230V/1750W)
Check/replace the wiring and repeat the diagnostic cycle to check
General earthing
connection
Washing heating
element
element
NO
Y
E
S
for any further alarms.
J14
J4
GND
Fig. 4
28÷31Ω 230V 1750W
53/67
Replace the heating
element and repeat the
diagnostic cycle to check
for any further alarms.
J11 J13 J10 J8
J6
MAIN PCB
If there are burns on the circuit
board, see page 65
599 72 97-24
E69
J7