BURST OF STEAM
Burst of steam works with both dry and steam ironing, as long as there is
water in the tank, and the temperature control dial is set above
•
Check that there is water in the tank.
•
Check that the temperature control dial is set at silk/wool
•
Wait until the light switches to green.
•
Press the
burst of steam button – you may have to press it 2 or 3
times to pump water through the system.
•
Leave 3 seconds between bursts, to allow the iron temperature to
recover.
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
•
Move the steam control to
•
Set the temperature control dial to the desired setting.
•
Wait until the light turns green then commence ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes, hanging
curtains, and furnishing fabrics.
•
Check that there is water in the tank.
Turn the temperature control dial to 'max'.
•
•
Wait until the light switches green.
•
Check that there is nothing behind the fabric that may be damaged by
the steam or heat.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Hold the iron, with the soleplate vertical, close to (but not touching) the fabric.
•
Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
•
Leave 3 seconds between bursts, to allow the temperature to recover.
AFTER USE
•
Turn the temperature control dial to 'minimum', move the steam control to
•
Unplug the iron.
•
Lift the top of the water inlet cover to open it.
•
Hold the iron over a sink, turn it upside down, and drain the water from
the tank.
CAUTION: The water may be hot.
•
Sit the iron on its heel.
•
Leave it to cool down completely.
•
When it is cold, wipe off any moisture, and close the water inlet cover.
•
Store the iron on its heel, to avoid corrosion and damage to the
soleplate.
MAX
no steam.
TEMPERATURE
CONTROL DIAL
8
silk/wool.
or higher.
STEAM CONTROL
no steam.
MAX