Table of Contents
Advertisement
BURST OF STEAM
Burst of steam works with both dry and steam ironing, as long as
there is water in the tank, and the temperature control dial is set
above
silk/wool.
•
Check that there is water in the tank.
•
Check that the temperature control dial is set above
•
Wait until the Thermostat light turns off.
•
Press the
burst of steam button – you may have to press it 2
or 3 times to pump water through the system.
•
Leave 3 seconds between bursts, to allow the iron temperature to recover.
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
•
Move the steam control to
•
Set the temperature control dial to the desired setting.
•
Wait until the Thermostat light turns off, then commence ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes, hanging
curtains, and furnishing fabrics.
•
Check that there is water in the tank.
Turn the temperature control dial to 'max'.
•
•
Wait until the light switches off.
•
Check that there is nothing behind the fabric that may be damaged
by the steam or heat.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Hold the iron, with the soleplate vertical, close to (but not touching)
the fabric.
•
Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
•
Leave 3 seconds between bursts, to allow the temperature to recover.
AFTER USE
Turn the temperature control dial to 'synthetic', move the steam
•
control to
no steam.
•
Unplug the iron.
•
Lift the top of the water inlet cover to open it.
•
Hold the iron over a sink, turn it upside down, and drain the
water from the tank.
CAUTION: The water may be hot.
•
Sit the iron on its heel.
•
Leave it to cool down completely.
•
When it is cold, wipe off any moisture, and close the water inlet cover.
•
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
no steam.
2
6
burst of
steam
button
silk/wool.
cool spray
mist
button
wate
2
Advertisement
Table of Contents
