Table of Contents
Advertisement
l
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
•
Move the steam control to
•
Set the temperature control dial to the desired setting.
•
Wait until the light switches off, then commence ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes,
hanging curtains, and furnishing fabrics.
•
Check that there is water in the tank.
•
Turn the temperature control dial to 'max'.
•
Wait until the light switches off.
i
•
Check that there is nothing behind the fabric that may be
damaged by the steam or heat.
•
Check that pockets, turn-ups and cuffs are empty.
•
Hold the iron, with the soleplate vertical, close to (but not
touching) the fabric.
•
Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
•
Leave 3 seconds between bursts to allow the temperature to recover.
AFTER USE AND STORING
•
Turn the temperature control dial to 'nylon', move the steam control
to
no steam.
•
Unplug the iron.
•
To open the water inlet, press the water inlet cover downwards until it
clicks.
•
Hold the iron over a sink, turn it upside down, and drain the water
from the tank.
CAUTION: The water may be hot.
•
Sit the iron on its heel.
•
Press the water inlet cover downwards then release it to close the
water inlet.
•
Leave it to cool down completely.
•
When it is cold, wipe off any moisture.
•
The cord can be wrapped around the heel of your iron for storing. Use the clip to secure the
last section of cord as shown.
•
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
H B
no steam.
g
m
j
max
f
max
n
max
max
2
r
6
o
e
l
k
max
e
m
Advertisement
Table of Contents
Need help?
Do you have a question about the RHC1200 and is the answer not in the manual?
Questions and answers