Omron WT30-CA2M Operation Manual page 30

Nomenclature and Functions
Channel Setting Switch
(WCH)
Mode Selection Switch
Special Function Switch
Power Supply Terminals
I/O Terminals
Antenna Terminal
Function Setting Switch
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Set the communications frequency. For details on frequencies, refer to Appen-
dix F Frequency Table on page 105. The default is 02.
W CH
Setting range: 01 to 34, 51 to 83
(The channels 01/51 cannot be used for this product in China.)
X10 X1
Set the operation mode of the Serial Slave Station (three positions).
Switch setting
RUN
RUN
TEST
TEST
SET
SET
By switching the operating mode, a software reset is performed, and the set
value (setting switch setting) is read.
Use this switch to clear the recorded signal strength or to return to the factory
settings.
ENTER
ON
OFF
Supplies 24-VDC (allowable voltage range: 20.4 or 26.4 VDC) power to the
WT30 Terminal. The terminal construction uses a screwless terminal block
(Phoenix Contact: FFKDS/V1-5.08 or equivalent).
Connect the I/O contact signals.
Install an antenna on both the right and left sides. Always use two antennas.
Make the detailed settings for I/O Slave Station operations in RUN mode,
TEST mode, and SET mode.
No. Mode
1 RUN mode Holds I/O status data when a
communications error
occurs.
2 Input hold
3 Input filter: 100 ms
4 TEST mode Signal strength monitor dis-
abled
5 All channels automatically
selected
6 Installation test function
7 to Not used. ---
10
Operation mode
RUN mode
TEST mode
SET mode
ON functions
Clears I/O status data when
a communications error
occurs.
Normal mode
Input filter: 10 ms
Signal strength monitor
enabled
Specified channel selected
Nothing done.
---
Section 1-2
OFF functions
11