Related Manuals for Acdeos VERSA SL Step
Summary of Contents for Acdeos VERSA SL Step
- Page 1 VERSA SL Step Condensed Manual ACDEOS BV Touwbaan 1A 2352 CZ Leiderdorp Netherlands WWW.ACDEOS.COM Date: Jan 2022 ver.
-
Page 2: Technical Specifications
Technical specifications Product description Electrically operated step for mounting externally under the vehicle floor Installation Externally under the vehicle floor below the front, middle or rear door Dimensions Step depth 310 mm, Step width 1000 or 1200 mm depending on model Please refer to the installation drawings for detailed dimensions Weight 16-18 Kg depending on the model... -
Page 3: Safety Instructions
13. Repair and maintenance must be done by qualified and trained staff only. 14. If any parts need replacing, ensure only original Acdeos Parts are used. 15. If the anti slip profile on the step becomes worn, the step platform must be replaced. -
Page 4: Operation
Operation Deploy Operation procedure The vehicle should have the parking brake on before the step can be safely operated. The electronics receive a signal from the door switch or the driver switch. If a door switch is installed the step will move out automatically once the door is opened. Time needed for, either full deploy or stow cycle, is approximately 1,5 seconds. -
Page 5: Installation
Installation The installation must only be done by a company that is familiar with bodybuilding or modifying vehicles, and that have the trained technical staff. Mechanical Installation If you decide to hotwire the Note: It is needed to open and close the electric motor to open or close the step: make sure step during the installation, therefore you... - Page 6 Size 13 Figure 3 Figure 2 Step 2: Identify the location underneath the vehicle where the step will be positioned. Ensure the step can be installed Step 3: Assemble the step by in the required position without being obstructed by the chassis or other vehicle attaching the two swing assemblies to parts.
- Page 7 Figure 16 Parallel to ground Figure 15 Figure 17 Step 8: Adjust the step so that it is horizontal under the vehicle (Fig. 15 – 17). Step 9: adjust the step in the inward position forwards or backwards so that it sticks out as far as possible not exceeding 1 cm outward...
- Page 8 LED signal vehicle is stationary. The handbrake switch supplied with step. For safety reasons we recommend this signal is used. If you decide not to use this signal Acdeos cannot take any responsibility for any unsafe operation of the step.
- Page 9 Mechanical Installation of door switch: 12.5mm 1. Find the right place on the door to install the door switch, preferably around the area in the doorpost where you find the original door switch. Make sure there is minimum around 10-12 mm free space between the door and the door post when the door is closed at the place of installation.
- Page 10 IMPORTANT: The distance between the end of the switch and the door should still be 8.5 mm. Max torque to fit the switch is 5 Nm (This is light hand tight) If you use higher torque, the switch will break / crack, which will lead to unreliable door signals. If you decide to use driver operation, place a switch on the dashboard and connect it to the Green wire.
- Page 11 Using the Step: You should test the step after installation. Follow these instructions: 1. MOUNTING – Check that all the mounting bolts are in place and tightened. 2. MOUNTING – Bring the step out and have 2 people (Max 250kgs) step on it. Check whether the mounting of the step is strong enough for this weight.
- Page 12 We strongly recommend MOTIP White PTFE grease part nr 090204 for all parts in the step, do not use WD40 or silicon sprays Other similar PTFE grease sprays can also be used. This spray is also available at Acdeos under part number S150 https://www.motip.com/products/motip/industry/professional- technical-solutions/white-grease/...
- Page 13 6 Certification Product description Product VERSA SL Swing Side Step Type VERSA SL 1000 VERSA SL 1200 Production under responsibility of Company Acdeos BV Address Touwbaan 1A City 2352 CZ Leiderdorp Country Netherlands Website WWW.ACDEOS.COM Legal represented by Mr. A de Moes...
-
Page 14: Appendix 1; Electric Schedule
7 Appendix 1; electric schedule... -
Page 15: Appendix 2; Installation Drawings
8 Appendix 2; Installation drawings: AXS SWSS 1000 / 1200... - Page 16 ACDEOS BV Touwbaan 1A 2352 CZ Leiderdorp The Netherlands +31 71 5891819 Info@acdeos.com www ACDEOS.com...