Page 1: Table Of Contents
AXCOR PROFILE 600 TEATRO CL3016 AXCOR PROFILE 600 HC TEATRO CL3017 INSTRUCTION MANUAL INDEX Congratulations on choosing a Claypaky product! Page Contents We thank you for your custom. Safety information Please note that this product, as all the others in the rich Claypaky range, has been designed and made with Unpacking and preparation total quality to ensure excellent performance and best...
Page 2: Safety Information
1. SAFETY INFORMATION SAFETY INFORMATION IMPORTANT: Claypaky recommends you carefully read and keep the safety information on this product, also available in digital format at the following link: www.claypaky.com Ref: [FIS00W - Safety Information Axcor 600 series] INFORMAZIONI DI SICUREZZA IMPORTANTE: Claypaky raccomanda di leggere accuratamente e conservare le informazioni di sicurezza relative a questo prodotto, sempre reperibili in versione digitale al seguente link: www.claypaky.com...
Page 3: Unpacking And Preparation
2. UNPACKING AND PREPARATION 2 x 183102/805 Packing contents - Fig. 1 LOCKED UNLOCKED PAN Mechanism Lock and Release (every 90°) - Fig. 2 TILT Mechanism Lock and Release (every 45°) - Fig. 3 AXCOR PROFILE 600 TEATRO...
Page 4: Installation And Start-Up
3. INSTALLATION AND START-UP 3.1 Installing the fixture Installing the projector - Fig. 4 The projector can be installed on the floor resting on special rubber feet, on a truss or on the ceiling or wall. WARNING: with the exception of when the projector is positioned on the floor, the safety cable must be fitted. (Cod. 105041/001 available on request). This must be securely fixed to the support structure of the projector and then connected to the fixing point at the centre of the base.
Page 5: Connecting The Control Signal Line: Dmx / Art-Net
Mains Connecting to the mains supply - Fig. 6 3.3 Connecting the control signal line: DMX / Art-Net DMX 512 3 PIN SIGNAL SCREEN SIGNAL DMX 512 5 PIN SCREEN SIGNAL SIGNAL Connecting to the control signal line (DMX) - Fig. 7 Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity.
Page 6 Reversal of the display - Fig. 9 To activate this function, press UP and DOWN keys simultaneously while the display is in the rest mode. This status will be memorised and maintained even for the next time it will be switched on. To return to the initial state, repeat the operation all over again. Setting the projector starting address On each projector, the starting address must be set for the control signal (addresses from 1 to 512).
Page 7: Maintenance
4. MAINTENANCE 4.1 Opening the covers 1/4 Turn 1/4 Turn 1/4 Turn CLICK!! Locking and releasing Pan and Tilt movements - Refer to the instructions in the UNPACKING AND PREPARATION section. Opening the head covers - Fig. 10. Closing the head covers - Fig. 11. ‘...
Page 8: Periodical Cleaning
4.2 Periodical cleaning NOTE: keep a careful cleaning Upper side of the ''CMY/colour filters assembly'' to prevent rapid deterioration. Light collimation system This product contains internal light collimation system. Avoid intense light from any angle. Lower side Periodical cleaning - Fig. 12 To ensure optimal operation and performance for a long time it is essential to periodically clean the parts subject to dust and grease deposits.
Page 9: Effects Module Removal
4.3 Effects module removal Lower side Upper side Extraction of the effect modules: Preliminary operations - Fig. 13. NOTE: - Do not disconnect wiring harnesses when the fixtures is switched-on, to avoid to damage electronic boards. - Do not switch-on the fixtures with wiring harness disconnected. ‘...
Page 10 Lower side Upper side Extraction of the effect modules: Preliminary operations - Fig. 14. NOTE: - Do not disconnect wiring harnesses when the fixtures is switched-on, to avoid to damage electronic boards. - Do not switch-on the fixtures with wiring harness disconnected. AXCOR PROFILE 600 TEATRO...
Page 11 Upper side Extraction of the effect modules - Fig. 15. IMPORTANT: Grasp the modules using the support structure and not the details which could get damaged. Insertion of the effect modules: Repeat the operations indicated in Fig. 15, 16, 17 and 18 in reverse order. ‘...
Page 12 Upper side Extraction of the effect modules - Fig. 16. IMPORTANT: Grasp the modules using the support structure and not the details which could get damaged. Insertion of the effect modules: Repeat the operations indicated in Fig. 15, 16, 17 and 18 in reverse order. AXCOR PROFILE 600 TEATRO...
Page 13 Lower side Extraction of the effect modules - Fig. 17. IMPORTANT: Grasp the modules using the support structure and not the details which could get damaged. Insertion of the effect modules: Repeat the operations indicated in Fig. 15, 16, 17 and 18 in reverse order. ‘...
Page 14: Cleaning Of The Filters
4.4 - Cleaning of the filters 1/4 Turn Cleaning of the filters - Fig. 18. AXCOR PROFILE 600 TEATRO...
Page 15 1/4 Turn Cleaning of the filters - Fig. 19. ‘ Continue AXCOR PROFILE 600 TEATRO...
Page 16: Rotating Gobos
4.5 - Rotating gobos Bearing group replacement - Fig. 20 GOD019/011 GOD019/012 INDEX 1 ±0.1 GOD019/014 GOD019/010 GOD019/009 GOD019/013 GOD019/008 25 ±0.1 Replacing rotating gobos (max 20 mm image – thickness 1 mm) - Fig. 21 - The rotating gobo wheel only use dichroic glass gobos (it is not possible to use metal gobos); - For more information contact Claypaky;...
Page 17 COATED GLASS GOBOS TYPE 1 COATED GLASS GOBOS TYPE 2 GOBO DI VETRO DICROICI TIPO 1 GOBO DI VETRO DICROICI TIPO 2 Coated side Coated side towards Grey/Black side light source away from light source Uncoated side Reflective side towards light source To determine which side of a godo is coated, hold an odject up to it.
Page 18: Battery Removal
4.6 Battery removal This product contains a rechargeable battery. To preserve the environment, please dispose the battery at the end of its life according to the regulation in force. AXCOR PROFILE 600 TEATRO...
Page 19: Dimensions
5. DIMENSIONS (23.90") (22.44") (30.91") (16.10") (25.04") (12.95") (15.28") AXCOR PROFILE 600 TEATRO...

This manual is also suitable for:

Claypaky axcor profile 600 hc teatro Cl3016 Cl3017

ARRI CLAYPAKY AXCOR PROFILE 600 TEATRO Instruction Manual

Quick Links

Related Manuals for ARRI CLAYPAKY AXCOR PROFILE 600 TEATRO

Summary of Contents for ARRI CLAYPAKY AXCOR PROFILE 600 TEATRO

This manual is also suitable for:

Table of Contents