Operating Instructions - Frigidaire FHWW185WE2 Use & Care Manual

NOTE
The following instructions are for the control
panel. The same instructions can be used for
the remote control.
TO TURN UNIT ON:
DO THIS:
PRESS ON/OFF BUTTON
YOU WILL SEE:
NOTE: The unit will run in Cool mode with
Eco feature and Auto fan speed setting
when used for the first time. With the Eco
feature, when the room temperature is below
the set temperature, the fan will continue to
run for 3 minutes after the compressor shuts
o . The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature
is above the set temperature, at which time
the compressor turns back on. Eco feature
can be activated or deactivated by pressing
the Eco button, and cannot be activated in
'fan only' mode.
TO CHANGE TEMPERATURE SETTING:
DO THIS:
PRESS
PRESS

OPERATING INSTRUCTIONS

TO RAISE
TO LOWER
YOU WILL SEE:
The display will show the set temperature
during normal operation, press either up ( + )
or down ( – ) buttons
temperature to desired setting. If the up ( + )
or down ( – ) button is pressed continuously,
the unit will beep
temperature setting reaches the upper/lower
limits 90°F or 60°F.
TO ADJUST FAN SPEEDS:
DO THIS:
PRESS TO SELECT
YOU WILL SEE:
TO SET TO AUTO FAN:
DO THIS:
PRESS FAN BUTTON,
UNTIL AUTO IS HIGHLIGHTED
15
to adjust the
twice when the