Table of Contents
Advertisement
20
OPERATING INSTRUCTIONS
FAULT CODES:
If any of the below error codes show on the display, please contact your Frigidaire Customer
Service Center 1-800-944-9044(US) / 1-800-265-8352 (Canada).
Error Code
Description
EH00
Internal memory chip failure
EH60
Indoor ambient temperature sensor is open/short circuited
EH0b
Communication malfunction of main control board.
Note: The error codes will be separated into 2 parts. The display will alternate in 1 second
intervals. For example, if the fault code "EH00" occurs, the panel will first display "EH" for 1
second, then display "00" for another second. The error code will continue to loop until the
issue is resolved.
SHOWS "EH" FOR ONE SECOND:
Note: There are more than 3 error codes. If an error code appears on the display, turn o the
unit and restart it. If the error code persist, please contact your Frigidaire Customer Service
Center 1-800-944-9044(US) / 1-800-265-8352 (Canada).
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating
procedure, here are more features in your
control that you should become familiar with.
NOTE
The "Cool" circuit has an automatic 3 minute
time delayed start if the unit is turned o
and on quickly. This prevents overheating of
the compressor and possible circuit breaker
tripping. The fan will continue to run during
this time.
• There
is
a
2-Second
compressor shutting down when selecting
FAN ONLY. This is to cover the possibility
of having to roll through to select another
mode.
• The
control
will
temperature within 2 degrees Fahrenheit,
between 60°F and 90°F degrees.
delay
for
the
maintain
the
set
THEN SHOWS "00" FOR ANOTHER SECOND:
• After
a
power
memorize the last setting and return the
unit to the same setting once power is
restored.
• The unit should be operated in an indoor
temperature range of 60°F - 90°F (16°C -
32°C), and an outdoor temperature range
of 64°F - 109°F (18°C - 43°C). Performance
may be reduced outside of these operating
temperatures.
• Under high-temperature environments, the
operating fan speed may increase to ensure
that the machine can operate normally
under
extreme
conditions. The operating fan speed is
default to be the maximum fan speed. If the
setting fan speed or mode is changed, it
may display 'OH' for 3 seconds.
Fresh Air Vent Control (on some models)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (see Fig. 1)
2. Draw fresh air into the room - Fresh Air (see
Fig. 2)
3. Exchange air from the room - Vent Open (see
Fig. 3)
outage,
the
unit
high-temperature
will
Advertisement
Table of Contents
