Table of Contents
Advertisement
14
OPERATING INSTRUCTIONS
NOTE
The following instructions are for the
control panel. The same instructions can be
used for the remote control.
TO TURN UNIT ON:
DO THIS:
PRESS ON/OFF BUTTON
YOU WILL SEE:
NOTE: The unit will run in Eco(energy saver)
mode when powered on each time. In this
mode, the fan will continue to run for 3
minutes after compressor shuts o . The fan
then cycles on for 120 seconds at 10 minute
intervals until the room temperature is above
the set temperature, at which time the
compressor turns back on.
TO CHANGE TEMPERATURE SETTING:
DO THIS:
PRESS
PRESS
TO RAISE
TO LOWER
YOU WILL SEE:
The display will show the set temperature
during normal operation, press either up ( + )
or
down
( – )
buttons
temperature to desired setting. If the up ( + )
or down ( – ) button is pressed continuously,
the
unit
will
beep
temperature setting reaches the upper/lower
limits 90°F(32 °C) or 60°F(16 °C).
TO ADJUST FAN SPEEDS:
DO THIS:
PRESS TO SELECT
YOU WILL SEE:
TO USE AUTO FAN FEATURE:
DO THIS:
PRESS FAN BUTTON,
CHOOSE AUTO
to
adjust
the
twice
when
the
Advertisement
Table of Contents
