Table of Contents
Advertisement
Warranty and
Safety
:
Warranty
For Warranty information visit the following URL
Safety Guidelines:
•
Read this manual and become familiar with the tool before installing any clamps.
•
Protective eyewear should be worn when connecting and disconnecting the tool to compressed air
sources and during operation.
•
Wear appropriate gloves for handling steel while operating this tool, applying steel clamps and
removing the scrap clamp tail.
•
Tool should be firmly mounted before installing clamps.
•
Clamp tensioning or clamp tail retrieval can be immediately stopped by releasing pressure from the
foot pedal.
•
When applying clamps, care should be taken to insure fingers and loose clothing are not in the way
of the clamp being applied.
•
Never attempt to clamp objects which have the potential to burst, shatter or otherwise cause bodily
harm.
•
Disconnect air supply prior to maintenance and disassembly of tool components.
Important advice and warning to user, Read before applying clamps:
The Center Punch type clamp's lock and cut-off is achieved using considerable impact. This may cause
damage to the object being clamped.
Remember that a tighter clamp keeps the fitting more secure, but excess tension could damage the hose or
fitting. Fitting stem must have prominent barbs for proper retention inside the hose, but barbs must not be
sharp to prevent cutting into the hose. Hose, fitting and clamps must be compatible with each other and the
intended working environment. If in doubt, consult the hose or fitting manufacturer or call BAND-IT.
Clamping objects other than hose require similar precautions.
CAUTION: Improperly tightened clamps may result in dangerous hose assemblies, which could cause
injuries or property damage.
CAUTION: Abuse or use of hose outside the manufacturer's recommended conditions may cause it to
quickly deteriorate and become a safety hazard. This could result in serious injury or property damage.
Inspect and test hose assemblies frequently. Repair or replace at the slightest sign of damage or
deterioration.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
www.BAND-IT-IDEX.com/Warranty.html
www.BAND-IT-IDEX.com
2
GRSM17
Pneumatic
Center Punch
Tool
Document# P47050 Rev. -
© Copyright
BAND-IT-IDEX, Inc. 2008
All rights reserved
Advertisement
Table of Contents
