Table of Contents
Advertisement
6
Commissioning
Specifying the name and physical address of the device
6.4 Specifying the name and physical address of
6.5 Assigning an IP address
12 | 18
5. Compare the displayed serial number to the serial number on the device.
a
If the serial numbers do not match, the certificate key of a different device
was entered and transfer of data will not work later on.
6. Press 'OK' to confirm the entries.
a
The device has been added to the project. The security functions of "KNX
IP Secure" are activated automatically.
Commission device without "KNX IP Secure"
Commissioning without "KNX IP Secure"
Alternatively, the device can also be commissioned without KNX IP Secure. In
this case, the device is insecure and responds like other KNX devices without the
KNX IP Secure function.
To commission the device without KNX IP Secure, select the device in the 'Topo-
logy' or 'Devices' section and set the 'Secure commissioning option' to 'Deactiv-
ated' in the 'Properties' area of the 'Settings' tab.
the device
A unique device name helps recognize and find the device in a KNXnet/IP visualiz-
ation or within a project in ETS.
w
The device has been added to the project.
1. Select the device in the 'Topology' or 'Devices' section.
2. In the 'Properties' section, switch to the 'Settings' tab.
3. In the 'Name' input field, enter a unique name of 30 characters maximum for
the selected device.
4. In the 'Physical address' input field, enter the physical address of the device
The address must be as yet unassigned.
a
The settings are saved automatically.
For details on the IP address and additional network settings, contact your local
network administrator.
w
The device has been added to the project.
1. Select the device in the 'Topology' or 'Devices' section.
2. In the 'Properties' section, switch to the 'IP' tab.
3. Make the desired IP address settings.
a
The settings are saved automatically in the ETS project.
4. Saving settings in the device. To do so, use the ETS software for full program-
ming (menu item: "Program" > "Physical address & application program").
The following settings are possible:
●
Obtain IP address automatically
If you select this option, the device is automatically assigned an IP address.
This happens either via an DHCP service in the network or, if no DHCP service
A6V11689762_en--_d
Advertisement
Table of Contents
