Table of Contents
Advertisement
DEPTH OF CUT ADJUSTMENT (FIG. 4)
*
The depth of cut is controlled by raising and lowering the table
as illustrated in Fig.4. The table raises and lowers on four preci-
sion steel ground columns.
*
To Adjust: Loosen the two head assembly lock knob (A), and
turn the elevating handwheel (В).
*
When required depth is obtained, lock the two head assembly
lock knobs In order to maintain the current depth.
+
A scale (С) is located on the right front column for easy
reading.
*
The maximum depth of cut on full width planing is 1/8". A limiter
(D) is provided to limit the depth of cut. If the workpiece to be
cut is less than ó", the allowable maximum depth of cut is no
more than 1/4" (6 mm) in one pass.
ANTI-KICKBACK FINGERS (FIG. 5)
Anti-kickback fingers (A) are provided on your planer to prevent
kickback. These fingers operate by gravity and it is necessary to
inspect them occasionally.
In order for the anti-kickback fingers to move freely and operate
correctly, you must clean off any dust, particles or residue left
behind.
FEED ROLLER SPEED CONTROL (FIG. 6)
The 30-125CE М1 Planer is equipped with a spiral, serrated infeed
roller and rubber outfeed roller
When the feed rollers are engaged, they turn and feed the stock.
The feed rollers slow automatically when the machine
is under
heavy load in order to gives great results under all planing condi-
tions. The feed roller are driven by a chain and sprocket drive, which
takes power directly from the cutterhead through the oil bath gear-
box.
To engage: the feed rollers, pull out the lever as illustrated іп (Fig.6).
То
disengage:
the feed
rollers, push
the lever back
in towards
machine.
To change: the feed speed, push the lever in for 20 FPM, or pull lever
out for 16 FPM. Set the lever in neutral position for zero speed.
Note: speed change
can only be changed
when the machine
is running.
WARNING !
DISCONNECT THE MACHINE BEFORE PERFORMING ANY ADJUSTMENTS!
FAILURE TO COMPLY CAN CAUSE SERIOUS INJURIES TO THE MACHINE
AND THE WORK OPERATOR!
CHECKING PULLEY (FIG. 7)
To verify that motor pulley (B) is in line with the shaft pulley of (A),
using the edge of a straight scale check to see if they are on-line
with each other.
Advertisement
Table of Contents
