Table of Contents
Advertisement
SAFETY RULES
READ CAREFULLY BEFORE OPERATING THE MACHINE
Learn the machine's applications and limitations, as
well as the specific potential hazards particular to this
machine.
Follow available
safety instructions and
safety rules carefully.
Keep working area clean and
be sure adequate
lighting is available.
Do not wear
loose
clothing, gloves, bracelets,
necklaces,
or ornaments.
Wear
face, eye, ear,
respiratory and body protection devices, as indicated
for the operation or environment.
Keep hands
well away
from cutterhead
and
all
moving parts. Do not clear chips and sawdust away
with hands. Use a brush.
Keep guards in place and in working order.
If a
guard
must
be
removed
for maintenance
or
cleaning make sure it is properly attached before
using the fool again.
Do not push the cutting tool to hard. The cutting tool
will perform better and be safer working at the rate for
which if was designed. Feed work into a blade against
the direction of rotation of the blade.
Whenever
possible
use
a dust
collector
with
shaving hood to minimize health hazards.
Be positive that hold-downs
and
anti-kickback
devices
are
positioned
properly,
and
that
the
workpiece is being fed through the cutting tool in the
tight direction.
9.
Never leave the machine with the power on.
10. Do not use a dull, bent or cracked cutting tool.
11. Never stand on tool. Serious injury could occur if
the tool is tipped or if the cutting tool is unintentionally
contacted.
12. Make
sure tool is properly grounded.
If tool is
equipped
with three-prong
plug, it should
be
plugged
into а three-pole electrical
receptacle.
Never remove the third prong.
13. Always disconnect tool before servicing and when
changing accessories such as blades and cutters.
14. Make sure that switch is in "OFF" position before
plugging in cord.
15. Be sure that key and
adjusting wrenches
have
been removed before turning power on.
16. Use only accessories designed for the machine.
17. Clamp workpiece or guide prevent injury.
18. Do not start any operation before checking that
the cutters are tight to cutterhead also check if the
cutters are positioned at the same level.
19. Use
caution
when
placing
hands
near
the
cutterhead, knives are extremely sharp.
20. Use ONLY
recommended
accessories.
Use of
accessories
NOT
recommended
by
General
International may result in a risk of injury.
21. Do not use this planer for other than it's inten-
ded
use.
If used
for other
purposes,
General
International
disclaims any real or implied war
гапіу and holds itself harmless for any injury, which
may result from that use.
GENERAL ® INTERNATIONAL guarantee
All component parts of GENERAL INTERNATIONAL
machinery are carefully inspected during all production stages and each
machine
is thoroughly inspected upon completion of assembly.
Because of quality, GENERAL INTERNATIONAL agrees to
repair or replace any genuine part or parts which, upon examination, proves to be defective in workmanship or material
within a period of 24 months from date of purchase.In order to obtain warrantee, all defective parts must be returned pre-
paid to GENERAL INTERNATIONAL MFG. Co Ltd. Repairs made without our written authorization voids all guarantees.
Advertisement
Table of Contents
