Advertisement
FAULT
E7
E8
E9
E11
Light off
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
The alarm E7 is visualized at the end of the cycle that comes,
however, brought to the end since the operation of the dishwasher is
not harmed.
E11: Contact the after-sales service.
To "reset" an alarm is necessary:
Open and close the door, or turn off and on the machine. At this point
is possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
24
Istruzioni per l'utente
Turbine flow-regulator malfunction
(for the relevant models only)
The appliance is not able to "measure" the
amount of water loaded accurately. Interrupt the
program and switch off the dishwasher. Switch
the dishwasher back on, program it again and
start the washing cycle. If the problem persists,
contact the after-sales service.
Alternate washing system malfunction
Interrupt the program and switch off the dishwasher.
Switch the dishwasher back on, program it again
and start the washing cycle. If the problem persists,
contact the after-sales service.
Water intake system malfunction
Contact the after-sales service.
Wash motor pump does not work
Light on
DESCRIPTION
Light flashing
Advertisement
