Page 1
10MHZ Data, drawings, and other material contained herein are proprietary to Cross Technologies, Inc., but may be reproduced or duplicated without the prior permission of Cross Technologies, Inc. for purposes of operating the equipment. When ordering parts from Cross Technologies, Inc., be sure to include the equipment model number, equipment serial number, and a description of the part.
All Cross Technologies, Inc. products are warranted against defective materials and workmanship for a period of one year after shipment to customer. Cross Technologies, Inc.’s obligation under this warranty is limited to repairing or, at Cross Technologies, Inc.’s option, replacing parts, subassemblies, or entire assemblies. Cross Technologies, Inc. shall not be liable for any special, indirect, or consequential damages.
+3 dBm ± 3 dB, 10MHz reference signal is connected to the external reference input. The 2117 is powered by a 100-240 ± 10% VAC power supply, and in a 1 3/4” X 19” X 19”...
All manuals and user guides at all-guides.com 1.2 Technical Characteristics TABLE 1.0 2117-8485 Up/Downconverter Specifications* EQUIPMENT SPECIFICATIONS* SPECIFICATIONS* Input Input Characteristics DOWN 50Ω/14 dB 50Ω/14 dB Impedance/Return Loss Frequency 1.80-1.90 GHz 8.40-8.50 GHz Noise Figure, Max. 20 dB @ max gain 25 dB @ max gain...
2.0 Installation 2.1 Mechanical - The 2117-8485 consists of one RF PCB housed in a 1 RU (1 3/4 inch high) by 14 inch deep chassis. A switching, ± 12, +24, +5 VDC power supply provides power for the assemblies. The 2117-8485 can be secured to a rack using the 4 holes on the front panel.
Page 6
Lights YELLOW when external Lights RED when PLL Lights GREEN when DC voltage is 10MHz reference is active. comes out of lock. present from AC power supply. 10MHZ ALARM POWER FIGURE 2.2 2117-8485 Front Panel Controls and Indicators 2117-8485 Manual Page 6 11/14/19...
All manuals and user guides at all-guides.com 2.4 Installation / Operation 2.4.2 Installing and Operating the 2117-8485 Downconverter 1.) Connect -20 dBm to 0 dBm signal 8.4 to 8.5 GHz, RF1 INPUT, J102 (Figure 2.1). 2.) Connect RF1 OUT, J101 to the external equipment.
G. Top Cover - There are no serviceable parts inside the product so, the Top Cover should not be removed. If the Top Cover is removed the ground strap and associated screw MUST BE REINSTALLED prior to Top Cover screw replacement. FAILURE TO DO this may cause INGRESS and/or EGRESS emission problems. 2117-8485 Manual Page 9 11/14/19...
Page 10
All manuals and user guides at all-guides.com ROSS ECHNOLOGIES, INC. 6170 Shiloh Road Alpharetta, Georgia 30005 (770) 886-8005 FAX (770) 886-7964 Toll Free 888-900-5588 WEB www.crosstechnologies.com E-MAIL info@crosstechnologies.com 2117-8485 Manual Page 10 11/14/19...
Need help?
Do you have a question about the 2117 and is the answer not in the manual?
Questions and answers