Stihl FS 56 Instruction Manual page 16

13 Starting / Stopping the Engine
13.1.2 Version with Loop Handle
3
2
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop positions.
13.1.3 Function of stop switch and ignition
system
The stop switch is normally in the Run position,
i.e. when it is not depressed: The ignition is
switched on – the engine is ready to start. If the
stop switch is moved to the 0 position, the igni‐
tion is switched off. The ignition is switched on
again automatically after the engine stops.
13.2 Starting the Engine
► Press the manual fuel pump bulb (4) at least
five times – even if the bulb is filled with fuel.
0458-547-0121-F
1
4
13.2.1 Cold engine (cold start)
► Press in the choke lever (5) and turn it to g
at the same time.
13.2.2 Warm engine (warm start)
► Press in the choke lever (5) and turn it to < at
the same time.
Also use this setting if the engine has been run‐
ning but is still cold.
13.2.3 Cranking
► Place the unit on the ground: It must rest
securely on the engine support and the deflec‐
tor.
► If fitted: Remove the transport guard from the
cutting attachment.
To reduce the risk of accidents, check that the
cutting attachment is not touching the ground of
any other obstacles.
► Make sure you have a firm footing, either
standing, stooping or kneeling.
English
5
5
23