Sub-Zero 700BF Specifications page 7

Planning Information
Integrated Model 700 BF (I )
F R A M E D C A B I N E T R Y
SUB-ZERO
UNIT
CABINET
FRAME
CABINET
1
/ " (3)
8
DOOR
REVEAL
1
Traditional Frame – full overlay (top view).
SUB-ZERO
UNIT
CABINET
FRAME
1
CABINET
1
/ " (3)
8
DOOR
REVEAL
Traditional Frame – standard overlay
(top view).
S
SUB-ZERO
UNIT
CABINET
FRAME
1
CABINET
1
/ " (3)
8
DOOR
REVEAL
3
Traditional Frame – / " (10) offset
8
(top view).
Dimensions in parentheses are in
millimeters unless otherwise specified.
F R A M E D C A B I N E T R Y A P P L I C A T I O N S
Framed cabinetry applications present you with different
questions to address. The illustrations on this page show
common applications of framed cabinetry. These are not
meant to be the only alternatives, but are suggestions
from designers around the country.
IMPORTANT NOTE: The depth of each Integrated unit is
24" (610) from the front of the unit to its back. You must
allow for the thickness of the panel you are applying when
24
planning for the finished rough opening depth if you want
(610)
TO WALL
the front panel to be flush with surrounding cabinetry. You
may have to move the unit back into drywall or bring the
cabinets forward to achieve a flush fit. Refer to the
illustrations.
PANEL
Illustrations on the following pages give dimensions for an
Integrated drawer unit installed within a framed cabinetry
27
(686)
beaded inset application. Review the illustrations, giving
particular attention to the overall panel specifications.
2
T
24
(610)
TO WALL
PANEL
27
(686)
2
T
24
(610)
TO WALL
2
PANEL
27
(686)
7