Copying From Digital Equipment (Dubbing) "0.00 - Panasonic Digital Palmcorder PalmSight PV-DV600 Operating Instructions Manual

Special Features
Copying from Digital Before you begin...
Equipment
(dubbin g)
. Man both Palmcorders to their power
High quality digital-to-digital copying can * Connect the two Palmcorders using the DV
be accomplished if both Palmcorders interface cable (4-pin to 4-pin).
incorporate the digital in/out IEEE 1394 * Turn both Palmcorders ON.
interface (DV interface cable is not
SUPPER 1 Insert a pre-recorded tape into the
Source source (playing) Palmcorder, and set
(Playing) POWER to VCR.
Palmcorder
2 Insert a blank tape with the record
DV Input/ tab in place into the target (recording)
z— Output Palmcorder and set POWER to VCR.
3 Press PLAY on the source
Recording Palmcorder. When the tape reaches
Palmcorder the point you want to start dubbing,
press PAUSE.
4 Hold down REC and press PLAY the
target (recording) Palmcorder or
remote control (optional, page 74).
Press PAUSE to pause the tape at the
starting point of the dub.
5 Simultaneously, press PAUSE
Pere ce Cable Buttons on both units to begin the
d
dubbing.
unit, and then press STOP on playing
unit to end dubbing.
* When two Palmcorders are used for
dubbing, it is recommended that the
remote control VCR1 or VCR2 setting
should be used to avoid mis-operation.
* When two Palmcorders are connected
using the DV interface cable (not
supplied), a Video Editing Controller
cannot be used.
* Do not connect both an S-Video Cable or
A/V Cable and a DV Interface Cable.
CAUTION:
Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
o
Lo
©
O,
D
TI
(D
y
pbs
c
—
(D
o
CEU HESS
63